Siemens SINUMERIK 840D sl Operating Manual page 305

Parameter Description
LAB Repeat jump label for position
(only for G code)
PL Machining plane
(only for G code)
Machining
Face C
•
surface
Face Y
•
Peripheral surface C
•
(only for
Peripheral surface Y
ShopTurn) •
Position
At the front (face)
•
(only for
At the rear (face)
•
ShopTurn)
Outside (peripheral surface)
•
Inside (peripheral surface)
•
Coordinate
right-angled or polar
•
system
Dimensions in right-angled coordinates or polar coordinates (only for face C and
(only for
face Y)
ShopTurn)
right-angled or cylindrical
•
Dimensions in right-angled coordinates or cylindrical coordinates - (only for
peripheral surface C)
X0 X coordinate of 1st position (abs)
Y0 Y coordinate of 1st position (abs)
X1 ...X8 X coordinate for additional positions (abs or inc)
Y1 ...Y8 Y coordinate for additional positions (abs or inc)
(only for G code)
Face C and face Y - at right angles:
Z0 Z coordinate of the reference point (abs)
CP Positioning angle for machining area (only for face Y)
X0 X coordinate of 1st position (abs)
Y0 Y coordinate of 1st position (abs)
X1 ... X7 X coordinate for additional positions (abs or inc)
Incremental dimension: The sign is also evaluated.
Y1 ... Y7 Y coordinate for additional positions (abs or inc)
(only for
Incremental dimension: The sign is also evaluated.
ShopTurn)
Turning
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
Programming technology functions (cycles)
8.1 Drilling
Unit
mm
mm
mm
mm
mm
Degrees
mm
mm
mm
mm
305