Opening And Closing The Program - Siemens SINUMERIK 840D sl Operating Manual

12.2

Opening and closing the program

To view a program in more detail or modify it, open the program in the editor.
With programs that are in the NCK memory, navigation is already possible when opening.
The program blocks can only be edited when the program has been opened completely. You
can follow the opening of the program in the dialog line.
With programs that are opened via local network, USB FlashDrive or network connections,
navigation is only possible when the program has been opened completely. A progress
message box is displayed when opening the program.
Note
Channel changeover in the editor
When opening the program, the editor is opened for the currently selected channel. This
channel is used to simulate the program.
If you change over a channel in the editor, this does not influence the editor. Only when
closing the editor do you change into the other channel.
Procedure
Turning
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
3. Enter the user name and password and press the "OK" softkey to log
into the FTP server.
The content of the FTP server with its folders is displayed.
4. Press the "Log out" softkey after the required data processing has been
completed.
The connection to the FTP server is disconnected. In order to reselect
the FTP drive, you must log on again.
1. Select the "Program manager" operating area.
2. Select the desired storage location and position the cursor on the
program that you would like to edit.
3. Press the "Open" softkey.
- OR -
Press the <INPUT> key.
Managing programs
12.2 Opening and closing the program
641