Programming technology functions (cycles)
8.7 Additional cycles and functions in ShopTurn
Parameter
Function
Complete transfer
function
Coordinate
system
XP
ZP
Flush chuck
DIR
Clamping
S
α1
Z1
ZR
FR
Fixed
stop
520
Description
You can select between 5 different functions:
Complete transfer
•
Gripping
•
Withdrawing
•
Rear face
•
Front face
•
Gripping
Machine coordinate system (MCS)
•
The park position is specified in the machine coordinate system. Teaching
in the park position and angular offset is only possible in the machine
coordinate system.
Workpiece coordinate system (WCS)
•
The park position is specified in the workpiece coordinate system.
Park position of tool in X direction (abs)
Park position of tool in Z direction (abs)
Flush counterspindle chuck
Yes
•
No
•
Direction of rotation
Spindle rotates clockwise
•
Spindle rotates counter-clockwise
•
Spindle does not rotate
•
Clamping both spindles (only if spindles are not turning)
•
Clamping open
•
Clamping closed
Spindle speed – (only when the spindle rotates)
Angular offset
Transfer position (abs.)
Position, feedrate reduction (abs or inc)
Position from which a reduced feedrate is used.
Reduced feedrate
Travel to fixed stop
Yes
•
The counterspindle stops at a defined distance away from transfer position
Z1 and then traverses with a defined feedrate up to the fixed stop.
No
•
The counterspindle traverses to the transfer position Z1.
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
Unit
mm
mm
rev/min
Degrees
mm/rev
Turning