Changing A Cycle Call; Compatibility For Cycle Support - Siemens SINUMERIK 840D sl Operating Manual

6.9.5

Changing a cycle call

You have called the desired cycle via softkey in the program editor, entered the parameters
and confirmed with "Accept".
Procedure
See also
Generating a G code program (Page 204)
6.9.6

Compatibility for cycle support

The cycle support is generally upwards compatible. This means that cycle calls in NC
programs can always be recompiled with a higher software version, changed and then run
again.
When transferring NC programs to a machine with a lower software version, it cannot be
guaranteed, however, that the program will be able to be changed by recompiling cycle calls.
Turning
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
1. Select the desired cycle call and press the <Cursor right> key.
The associated input screen of the selected cycle call is opened.
- OR -
Press the <SHIFT + INSERT> key combination.
This starts the edit mode for this cycle call and you can edit it like a
normal NC block. This means that it is possible to generate an empty
block before the cycle is called. For instance, to insert something before
a cycle that is located at the beginning of the program.
Note: In edit mode, the cycle call can be changed in such a way that it
can no longer be recompiled in the parameter screen.
You exit the edit mode by pressing the <SHIFT + INSERT> key
combination.
- OR -
You are in the edit mode and press the <INPUT> key.
A new line is created after the cursor position.
Creating a G code program
6.9 Calling technology cycles
215