Save Kinematics (Cycle 450, Din/Iso: G450, Option); Cycle Run; Please Note While Programming - HEIDENHAIN TNC 640 User Manual

Touch Probe Cycles: Automatic Kinematics Measurement | SAVE KINEMATICS (Cycle 450, DIN/ISO: G450,
option)
19.3 SAVE KINEMATICS (Cycle 450, DIN/ISO:
G450, option)

Cycle run

With Touch Probe Cycle 450 you can save the active machine
kinematic configuration or restore a previously saved one. The
saved data can be displayed and deleted. 16 memory spaces in
total are available.

Please note while programming:

Always save the active kinematics configuration before
running a kinematics optimization. Advantage:
You can restore the old data if you are not satisfied
with the results or if errors occur during optimization
(e.g. power failure).
With the Restore mode, note that
the TNC can restore saved data only to a matching
kinematic configuration.
a change in the kinematics always changes the
preset as well. Set the preset again if necessary.
Saving and restoring with Cycle 450 should only
be performed if no tool carrier kinematics with
transformations is active
HEIDENHAIN | User's manual for cycle programming | 10/2017
19
683