Touch Probe Cycles: Automatic Presetting | PRESET FROM OUTSIDE OF RECTANGLE (Cycle 411,
DIN/ISO: G411)
Please note while programming:
Danger of collision!
Cycles for coordinate transformation must not be active during
execution of the touch probe cycles.
Do not activate the following cycles before using touch probe
cycles: Cycle 7 DATUM SHIFT,Cycle 8 MIRROR IMAGE, Cycle
10 ROTATION,Cycle 11 SCALING and 26 AXIS-SPECIFIC
SCALING
Reset any coordinate transformations beforehand
Danger of collision!
To prevent a collision between touch probe and workpiece, enter
high
estimates for the lengths of the 1st and 2nd sides.
Before a cycle definition you must have programmed a tool
call to define the touch probe axis.
HEIDENHAIN | User's manual for cycle programming | 10/2017
NOTICE
NOTICE
15
543