HEIDENHAIN TNC 640 User Manual page 564

15
Touch Probe Cycles: Automatic Presetting | PRESET FROM INSIDE OF CORNER (Cycle 415, DIN/ISO: G415)
Q305 Number in table?: Specify the row number
of the preset table/datum table to which the TNC
saves the coordinates of the corner; input range
0 to 9999. The TNC writes the entry to the preset
table or datum table depending on Q303:
Q303 = 1: The TNC writes to the preset table.
If the active preset is modified this change
immediately becomes effective. Otherwise an
entry is made in the specific row of the preset
table without automatic activation
Q303 = 0: The TNC writes to the datum table. The
datum is not automatically activated
Q331 New preset in reference axis? (absolute):
Coordinate in the reference axis at which the TNC
should set the corner. Default setting = 0. Input
range -99999.9999 to 99999.9999
Q332 New preset in minor axis? (absolute):
Coordinate in the minor axis at which the TNC
should set the corner. Default setting = 0. Input
range -99999.9999 to 99999.9999
Q303 Meas. value transfer (0,1)?: Specify
whether the determined preset is to be saved in
the datum table or in the preset table:
-1: Do not use! Is entered by the TNC when
old programs are read in (See "Characteristics
common to all touch probe cycles for presetting",
page 528)
0: Write the measured preset into the active
datum table. The reference system is the active
workpiece coordinate system
1: Write the measured preset into the preset table.
The reference system is the machine coordinate
system (REF system).
Q381 Probe in TS axis? (0/1): Specify whether
the TNC should also set the preset in the touch
probe axis:
0: Do not set the preset in the touch probe axis
1: Set the preset in the touch probe axis
564
HEIDENHAIN | User's manual for cycle programming | 10/2017