HEIDENHAIN TNC 640 User Manual page 554

15
Touch Probe Cycles: Automatic Presetting | PRESET FROM OUTSIDE OF CIRCLE (Cycle 413, DIN/ISO: G413)
Q305 Number in table?: Specify the row number
of the preset table/datum table to which the TNC
saves the coordinates of the center point; input
range 0 to 9999. The TNC writes the entry to the
preset table or datum table depending on Q303:
Q303 = 1:
If the active preset is modified this change
immediately becomes effective. Otherwise an
entry is made in the specific row of the preset
table without automatic activation
Q303 = 0:
datum is not automatically activated
Q331 New preset in reference axis? (absolute):
Coordinate in the reference axis at which the TNC
should set the stud center. Default setting = 0.
Input range -99999.9999 to 99999.9999
Q332 New preset in minor axis? (absolute):
Coordinate in the minor axis at which the TNC
should set the stud center. Default setting = 0.
Input range -99999.9999 to 99999.9999
Q303 Meas. value transfer (0,1)?: Specify
whether the determined preset is to be saved in
the datum table or in the preset table:
-1: Do not use! Is entered by the TNC when
old programs are read in (See "Characteristics
common to all touch probe cycles for presetting",
page 528)
0: Write the measured preset into the active
datum table. The reference system is the active
workpiece coordinate system
1: Write the measured preset into the preset table.
The reference system is the machine coordinate
system (REF system).
Q381 Probe in TS axis? (0/1): Specify whether
the TNC should also set the preset in the touch
probe axis:
0: Do not set the preset in the touch probe axis
1: Set the preset in the touch probe axis
554
The TNC writes to the preset table.
The TNC writes to the datum table. The
HEIDENHAIN | User's manual for cycle programming | 10/2017