Please Note While Programming - HEIDENHAIN TNC 640 User Manual

Visual Setup Control VSC (Software Option 136) | Workspace Global (Cycle 600)

Please note while programming:

In addition to the attribute Reference image, you can
also assign the attribute Error image to your images.
This assignment may impact the image evaluation.
Remember the following:
A reference image may never be an error image at
the same time.
If you change the monitoring area, this has an impact on
all images.
Ideally, you define the monitoring area only once at
the beginning and then make no or only little changes
to it.
The number of reference images will affect the accuracy
of the image evaluation. A high number of reference
images improves the quality of the evaluation.
Specify a sensible number of reference images in
parameter Q617 . (Approx. value: 10 images).
You can also create more reference images than you
have specified in Q617 .
Your machine must be prepared for camera-based
monitoring!
Danger of collision!
Danger of contaminating the camera due to open camera lid
with parameter Q613. This could lead to blurred images, the
camera may be damaged.
Close the camera lid before continuing with the process.
Danger of collision!
Danger of collision with automatic positioning of the camera. The
camera and your machine may be damaged.
Ask your machine manufacturer to tell you the point that the
camera pre-positions to. Your machine tool builder specifies
the coordinates which Cycle 600 positions to.
HEIDENHAIN | User's manual for cycle programming | 10/2017
NOTICE
NOTICE
18
671