15
Touch Probe Cycles: Automatic Presetting | PRESET FROM OUTSIDE OF CIRCLE (Cycle 413, DIN/ISO: G413)
Please note while programming:
The smaller the angle increment Q247 , the less
accurately the TNC can calculate the preset.
Minimum input value: 5°
Program a stepping angle to be less than 90°; input
range -120° to 120°
Danger of collision!
Cycles for coordinate transformation must not be active during
execution of the touch probe cycles.
Do not activate the following cycles before using touch probe
cycles: Cycle 7 DATUM SHIFT,Cycle 8 MIRROR IMAGE, Cycle
10 ROTATION,Cycle 11 SCALING and 26 AXIS-SPECIFIC
SCALING
Reset any coordinate transformations beforehand
Danger of collision!
To prevent a collision between touch probe and workpiece, enter
a
high
estimate for the nominal diameter of the stud.
Before a cycle definition you must have programmed a tool
call to define the touch probe axis.
552
NOTICE
NOTICE
HEIDENHAIN | User's manual for cycle programming | 10/2017
Need help?
Do you have a question about the TNC 640 and is the answer not in the manual?
Questions and answers