Please Note While Programming - HEIDENHAIN TNC 640 User Manual

Touch Probe Cycles: Automatic Presetting | RIDGE CENTER PRESET (Cycle 409, DIN/ISO: G409)

Please note while programming:

Danger of collision!
Cycles for coordinate transformation must not be active during
execution of the touch probe cycles.
Do not activate the following cycles before using touch probe
cycles: Cycle 7 DATUM SHIFT,Cycle 8 MIRROR IMAGE, Cycle
10 ROTATION,Cycle 11 SCALING and 26 AXIS-SPECIFIC
SCALING
Reset any coordinate transformations beforehand
Danger of collision!
To prevent a collision between touch probe and workpiece, enter
a high estimate for the ridge width.
Before a cycle definition you must have programmed a tool
call to define the touch probe axis.
HEIDENHAIN | User's manual for cycle programming | 10/2017
NOTICE
NOTICE
15
535