HEIDENHAIN TNC 640 User Manual page 578

15
Touch Probe Cycles: Automatic Presetting | PRESET IN ONE AXIS (Cycle 419, DIN/ISO: G419)
Q305 Number in table?: Specify the row number
of the preset table/datum table to which the TNC
saves the coordinates; input range 0 to 9999.
Q303 = 1:
If the active preset is modified this change
immediately becomes effective. Otherwise an
entry is made in the specific row of the preset
table without automatic activation
Q303 = 0:
datum is not automatically activated
Q333 New preset in TS axis? (absolute):
Coordinate at which the TNC should set
the preset. Default setting = 0. Input range
-99999.9999 to 99999.9999
Q303 Meas. value transfer (0,1)?: Specify
whether the determined preset is to be saved in
the datum table or in the preset table:
-1: Do not use! Is entered by the TNC when
old programs are read in (See "Characteristics
common to all touch probe cycles for presetting",
page 528)
0: Write the measured preset into the active
datum table. The reference system is the active
workpiece coordinate system
1: Write the measured preset into the preset table.
The reference system is the machine coordinate
system (REF system).
578
The TNC writes to the preset table.
The TNC writes to the datum table. The
HEIDENHAIN | User's manual for cycle programming | 10/2017