Fundamentals; Overview - HEIDENHAIN TNC 640 User Manual

17
17.1

Fundamentals

Overview

Danger of collision!
Cycles for coordinate transformation must not be active during
execution of the touch probe cycles.
Do not activate the following cycles before using touch probe
cycles: Cycle 7 DATUM SHIFT,Cycle 8 MIRROR IMAGE, Cycle
10 ROTATION,Cycle 11 SCALING and 26 AXIS-SPECIFIC
SCALING
Reset any coordinate transformations beforehand
The TNC must be specially prepared by the machine tool
builder for the use of a 3-D touch probe.
HEIDENHAIN only assumes liability for functionality of
the probing cycles if HEIDENHAIN touch probes are
used.
The TNC provides a cycle for the following special purpose:
Soft key Cycle
3 MEASURING
Cycle for defining OEM cycles
630
NOTICE
Touch Probe Cycles: Special Functions | Fundamentals
Page
631
HEIDENHAIN | User's manual for cycle programming | 10/2017