HEIDENHAIN TNC 640 User Manual page 15

Fundamentals | New and changed cycle functions of software 34059x-07
New and changed cycle functions of software
34059x-07
New Cycle 444 for three-dimensional probing of any coordinate,
See "3D PROBING (Cycle 444)", page 635
Cycle 451 has been expanded by parameter Q406. This makes
it possible to use KinematicsComp (software option 52) to
compensate the measured angle position errors of the rotary
axes, See "MEASURE KINEMATICS (Cycle 451, DIN/ISO: G451,
option)", page 686
Cycle 460 has been expanded by parameter Q455. This makes
it possible to measure, store, and compensate the deviations
determined by KinematicsComp (software option 52), See
"CALIBRATE TS (Cycle 460, DIN/ISO: G460)", page 642
In the protocol of the KinematicsOpt cycles 451 and 452 the
position of the measured rotary axes can be output before
and after optimization. See "MEASURE KINEMATICS (Cycle
451, DIN/ISO: G451, option)", page 686, See "PRESET
COMPENSATION (Cycle 452, DIN/ISO: G452, option)",
page 700
Cycle 225 has been expanded by parameters Q516, Q367 ,
and Q574. This makes it possible to define a preset for the
respective text position, as well as to scale the text length
and character height. The pre-positioning for engraving on a
circular path has changed, See "ENGRAVING (Cycle 225, DIN/
ISO: G225)", page 340
Cycle 861 has been expanded by parameters Q510, Q511, and
Q462. This makes it possible to program an overlap, a feed
rate factor, and a selectable retraction behavior. See "RADIAL
RECESSING (Cycle 861, DIN/ISO: G861)", page 437
Cycle 862 has been expanded by parameters Q510, Q511,
and Q462. This makes it possible to program an overlap, a
feed rate factor, and a selectable retraction behavior, See
"RADIAL RECESSING EXTENDED (Cycle 862, DIN/ISO: G862)",
page 441
Cycle 871 has been expanded by parameters Q510, Q511, and
Q462. This makes it possible to program an overlap, a feed
rate factor, and a selectable retraction behavior, See "AXIAL
RECESSING (Cycle 871, DIN/ISO: G871)", page 450
Cycle 872 has been expanded by parameters Q510, Q511,
and Q462. This makes it possible to program an overlap, a
feed rate factor, and a selectable retraction behavior, See
"AXIAL RECESSING EXTENDED (Cycle 872, DIN/ISO: G872)",
page 454
HEIDENHAIN | User's manual for cycle programming | 10/2017
15