HEIDENHAIN TNC 640 User Manual page 30
Hide thumbs
Also See for TNC 640:
- User manual (948 pages) ,
- Manual (56 pages) ,
- Operating instructions manual (64 pages)
Table of Contents
Advertisement
7.10
THREE-D CONT. TRAIN (Cycle 276, DIN/ISO: G276)....................................................................... 241
Cycle run.............................................................................................................................................. 241
Please note while programming:......................................................................................................... 242
Cycle parameters................................................................................................................................. 244
7.11
CONTOUR TRAIN DATA (Cycle 270, DIN/ISO: G270)......................................................................246
Please note while programming:......................................................................................................... 246
Cycle parameters................................................................................................................................. 246
7.12
TROCHOIDAL SLOT (Cycle 275, DIN/ISO: G275).............................................................................247
Cycle run.............................................................................................................................................. 247
Please note while programming:......................................................................................................... 249
Cycle parameters................................................................................................................................. 250
7.13
Programming Examples.................................................................................................................... 252
Example: Roughing-out and fine-roughing a pocket............................................................................ 252
Example: Pilot drilling, roughing-out and finishing overlapping contours.............................................254
Example: Contour train........................................................................................................................ 256
30
HEIDENHAIN | User's manual for cycle programming | 10/2017
Contents
Advertisement
Table of Contents
Need help?
Do you have a question about the TNC 640 and is the answer not in the manual?
Questions and answers