12
12.3 RESET ROTARY COORDINATE SYSTEM
(Cycle 801, DIN/ISO: G801)
Please note while programming:
The Cycle 801 RESET COORDINATE SYSTEM is
machine-dependent. Refer to your machine manual.
With Cycle 801 RESET COORDINATE SYSTEM you can
reset the settings you have made with Cycle 800 ADAPT
COORDINATE SYSTEM.
To reset Cycle 800, program Cycle 801 Koordinaten-
System zurücksetzen.
Cycle 800 limits the maximum permitted spindle
speed during eccentric turning. This results from a
machine-dependent configuration (implemented by your
machine tool builder) and the size of the eccentricity.
It is possible that you programmed a speed limit with
FUNCTION TURNDATA SMAX before programming Cycle
800. If the value of this speed limit is less than the
speed limit calculated by Cycle 800, the lower value
is effective. To reset Cycle 800, program Cycle 801.
This also resets the speed limit set by the cycle. The
speed limit is then effective that you programmed with
FUNCTION TURNDATA SMAX before calling the cycle.
372
Cycles: Turning | RESET ROTARY COORDINATE SYSTEM
HEIDENHAIN | User's manual for cycle programming | 10/2017
(Cycle 801, DIN/ISO: G801)