HEIDENHAIN TNC 640 User Manual page 56

1
Overview of touch probe cycles
The soft-key row shows the available groups of
cycles
Soft key Cycle group
Cycles for automatic measurement and compensation of workpiece
misalignment
Cycles for automatic workpiece presetting
Cycles for automatic workpiece inspection
Special cycles
Touch probe calibration
Cycles for automatic kinematics measurement
Cycles for automatic tool measurement (enabled by the machine tool
builder)
Cycles for VSC: camera-based monitoring of the setup situation (software
option 136)
If required, switch to machine-specific touch
probe cycles. These touch probe cycles can be
integrated by your machine tool builder.
56
Fundamentals / Overviews | Available Cycle Groups
HEIDENHAIN | User's manual for cycle programming | 10/2017
Page
502
526
584
630
642
502
718
656