Save Kinematics (Cycle 450, Din/Iso: G450, Option) 18.3; Cycle Run; Please Note While Programming - HEIDENHAIN TNC 620 User Manual

SAVE KINEMATICS (Cycle 450, DIN/ISO: G450, option) 18.3

18.3 SAVE KINEMATICS (Cycle 450,
DIN/ISO: G450, option)

Cycle run

With the touch probe cycle 450 you can save the active machine
kinematic configuration or restore a previously saved one. The
saved data can be displayed and deleted. 16 memory spaces in
total are available.

Please note while programming:

Always save the active kinematics configuration
before running a kinematics optimization. Advantage:
You can restore the old data if you are not
satisfied with the results or if errors occur during
optimization (e.g. power failure).
With the Restore mode, note that
the TNC can restore saved data only to a
matching kinematic configuration.
a change in the kinematics always changes the
preset as well. Set the preset again if necessary.
TNC 620 | User's Manual Cycle Programming | 3/2014
18
437