Preset From Outside Of Circle (Cycle 413, Din/Iso: G413); Cycle Run - HEIDENHAIN TNC 640 User Manual

Hide thumbs Also See for TNC 640:

Table of Contents

Touch Probe Cycles: Automatic Presetting | PRESET FROM OUTSIDE OF CIRCLE (Cycle 413, DIN/ISO: G413)

15.7 PRESET FROM OUTSIDE OF CIRCLE

(Cycle 413, DIN/ISO: G413)

Touch Probe Cycle 413 finds the center of a circular stud and

defines it as preset. If desired, the TNC can also enter the

coordinates into a datum table or the preset table.

1 Following the positioning logic, the TNC positions the touch

probe at rapid traverse (value from FMAX column) (See

"Executing touch probe cycles", page 497) to touch point 1. The

TNC calculates the touch points from the data in the cycle and

the safety clearance from the SET_UP column of the touch

probe table.

2 Then the touch probe moves to the entered measuring height

and runs the first probing process at the probing feed rate

(column F). The TNC derives the probing direction automatically

from the programmed starting angle.

3 Then the touch probe moves in a circular arc either at measuring

height or at clearance height to the next starting point

probes the second touch point.

4 The TNC positions the probe to starting point

starting point

to probe the third and fourth touch points.

5 Finally the TNC returns the touch probe to the clearance height

and processes the determined preset depending on the cycle

parameters Q303 and Q305 (See "Characteristics common to

all touch probe cycles for presetting", page 528) and saves the

actual values in the Q parameters listed below.

6 If desired, the TNC subsequently measures the preset in the

touch probe axis in a separate probing.

Parameter number

HEIDENHAIN | User's manual for cycle programming | 10/2017

Actual value of center in reference axis

Actual value of center in minor axis

Actual value of diameter