Cycle Parameters - HEIDENHAIN TNC 640 User Manual

18

Cycle parameters

QS600 (string parameter) Name of monitoring
point?: Enter the name of your monitoring file
Q616 Feed rate for positioning?: Feed rate the
TNC uses to position the camera. Here, TNC
moves to a position defined by the machine tool
builder.
Q309 PGM stop if tolerance exceeded?: (0/1)
Specify whether the TNC stops the program if an
error is detected.
0:
Even if not all reference images have been
generated yet, no stop is performed. This means
that the generated image will not be displayed on
the screen. Parameter Q601 is written to even if
Q309=0.
1:
the generated image will be displayed in the
screen. If not enough reference images have been
generated yet, every new image will be displayed
on the screen until the TNC has generated enough
reference images. If an error is detected, the TNC
will display a message.
Q617 Number of reference images?: Number of
reference images that are required by the TNC for
monitoring.
672
Visual Setup Control VSC (Software Option 136) | Workspace Global (Cycle 600)
Program does not stop if an error is detected.
Program will stop after detecting an error,
NC blocks
4 TCH PROBE 600 GLOBAL WORKING
SPACE
QS600="OS" ;MONITORING POINT
Q616=500 ;FEED RATE FOR
POSITIONING
Q309=1 ;PGM STOP TOLERANCE
Q617=10 ;REFERENCE IMAGES
HEIDENHAIN | User's manual for cycle programming | 10/2017