Configuring IPv6 Over IPv4 Parameters
This section provides several examples of the features that must be configured in order to
implement IPv6 over IPv4 relay services.
•
•
Tunnel Ingress Node
This configuration shows how the interface through which the IPv6 over IPv4 traffic leaves the
node. This must be configured on a network interface.
CLI Syntax: config>router
The following displays configuration output showing interface configuration.
A:ALA-49>configure>router# info
----------------------------------------------
...
...
----------------------------------------------
A:ALA-49>configure>router#
7710 SR OS Router Configuration Guide
Tunnel Ingress Node on page 67
Configuring an IPv4 BGP Peer on page 69
An Example of a IPv6 Over IPv4 Tunnel Configuration on page 70
Tunnel Egress Node on page 71
An Example of a IPv6 Over IPv4 Tunnel Configuration on page 72
static-route ::C8C8:C802/128 indirect 200.200.200.2
interface ip-int-name
address {ip-address/mask|ip-address netmask} [broadcast
all-ones|host-ones]
port port-name
interface "ip-1.1.1.1"
address 1.1.1.1/30
port 1/1/1
exit
IP Router Configuration
Page 67