Alcatel-Lucent 7710 SR OS Configuration Manual page 188

Router
Hide thumbs Also See for 7710 SR OS:
Table of Contents

Advertisement

route-table
Syntax
route-table [ip-prefix[/prefix-length] [longer | exact | protocol]] | [protocol protocol-name]
[all]]
route-table [family] summary
route-table tunnel-endpoints [ip-prefix[/prefix-length] [longer | exact | protocol]
route-table [ip-prefix[/prefix-length] next-hop-type tunneled
route-table [next-hop-type tunneled]
Context
show>router
Description
This command displays the active routes in the routing table.
If no command line arguments are specified, all routes are displayed, sorted by prefix.
Parameters
family — Specify the type of routing information to be distributed by this peer group.
ip-prefix[/prefix-length] — Displays routes only matching the specified ip-address and length.
longer — Displays routes matching the ip-prefix/mask and routes with longer masks.
exact — Displays the exact route matching the ip-prefix/mask masks.
protocol protocol-name — Displays routes learned from the specified protocol.
summary — Displays a route table summary information.
tunnel-endpoints — Specifies to include tunnel endpoint information.
next-hop-type tunneled — Displays only the tunneled next-hops. For each route entry, the tunnel
Output
Standard Route Table Output — The following table describes the standard output fields for the
route table.
Dest Address
Next Hop
Page 188
Values
ipv4 — Displays only those BGP peers that have the IPv4 family enabled and not
those capable of exchanging IP-VPN routes.
ipv6 — Displays the BGP peers that are IPv6 capable.
mcast-ipv4 — Displays the BGP peers that are IPv4 multicast capable.
mcast-ipv6 — Displays multicast IPv6 route table.
Values
ipv4-prefix:
ipv4-prefix-length:
ipv6
ipv6-prefix[/pref*:
prefix-length:
Values
local, sub-mgmt, managed, static, ospf, ospf3, isis, rip, aggregate, bgp, bgp-vpn
owner and tunnel ID is shown.
Label
The route destination address and mask.
The next hop IP address for the route destination.
a.b.c.d (host bits must be set to 0)
0 — 32
x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 — FFFF]H
d: [0 — 255]D
1 — 128ipv6
Description
7710 SR OS Router Configuration Guide

Advertisement

Table of Contents
loading

Table of Contents