Table of Contents
Advertisement
Common Configuration Tasks
Configuring IPv6 Over IPv4 Parameters
This section provides several examples of the features that must be configured in order to
implement IPv6 over IPv4 relay services.
•
•
Tunnel Ingress Node
This configuration shows how the interface through which the IPv6 over IPv4 traffic leaves the
node. This must be configured on a network interface.
CLI Syntax: config>router
The following displays configuration output showing interface configuration.
A:ALA-49>configure>router# info
----------------------------------------------
...
...
----------------------------------------------
A:ALA-49>configure>router#
Page 68
Tunnel Ingress Node on page 68
Learning the Tunnel Endpoint IPv4 System Address on page 70
Configuring an IPv4 BGP Peer on page 71
An Example of a IPv6 Over IPv4 Tunnel Configuration on page 72
Tunnel Egress Node on page 73
Learning the Tunnel Endpoint IPv4 System Address on page 74
Configuring an IPv4 BGP Peer on page 75
An Example of a IPv6 Over IPv4 Tunnel Configuration on page 76
static-route ::C8C8:C802/128 indirect 200.200.200.2
interface ip-int-name
address {ip-address/mask|ip-address netmask} [broadcast
all-ones|host-ones]
port port-name
interface "ip-1.1.1.1"
address 1.1.1.1/30
port 1/1/1
exit
7750 SR OS Router Configuration Guide
Advertisement
Table of Contents
