Alcatel-Lucent 7710 SR OS Configuration Manual page 128

proxy-arp-policy
Syntax
Context
Description
Default
Parameters
qos-route-lookup
Syntax
Context
Description
Page 128
[no] proxy-arp-policy policy-name [policy-name...(up to 5 max)]
config>router>interface
This command enables and configure proxy ARP on the interface and specifies an existing policy-
statement to analyze match and action criteria that controls the flow of routing information to and
from a given protocol, set of protocols, or a particular neighbor. The policy-name is configured in the
config>router>policy-options context.
Use proxy ARP so the 7710 SR responds to ARP requests on behalf of another device. Static ARP is
used when a 7710 SR needs to know about a device on an interface that cannot or does not respond to
ARP requests. Thus, the 7710 SR OS configuration can state that if it has a packet that has a certain
IP address to send it to the corresponding ARP address.
no proxy-arp-policy
policy-name — The export route policy name. Allowed values are any string up to 32 characters long
composed of printable, 7-bit ASCII characters. If the string contains special characters (#, $,
spaces, etc.), the entire string must be enclosed within double quotes. The specified policy
name(s) must already be defined.
qos-route-lookup [source | destination]
no qos-route-lookup
config>router>interface
config>router>interface>ipv6
This command enables QoS classification of the ingress IP packets on an interface based on
the QoS information associated with routes in the forwarding table.
If the optional destination parameter is specified and the destination address of an incoming
IP packet matches a route with QoS information the packet is classified to the fc and priority
associated with that route, overriding the fc and priority/profile determined from the sap-
ingress or network qos policy associated with the IP interface. If the destination address of
the incoming packet matches a route with no QoS information the fc and priority of the
packet remain as determined by the sap-ingress or network qos policy.
If the optional source parameter is specified and the source address of an incoming IP
packet matches a route with QoS information the packet is classified to the fc and priority
associated with that route, overriding the fc and priority/profile determined from the sap-
ingress or network qos policy associated with the IP interface. If the source address of the
incoming packet matches a route with no QoS information the fc and priority of the packet
remain as determined by the sap-ingress or network qos policy.
7710 SR OS Router Configuration Guide