Alcatel-Lucent 7710 SR OS Configuration Manual page 132

Default
Parameters
strip-label
Syntax
Context
Description
Default
tos-marking-state
Syntax
Context
Description
Page 132
The no form of the command removes a static ARP entry.
No static ARPs are defined.
unnumbered — Specifies the static ARP MAC for an unnumbered interface. Unnumbered interfaces
support dynamic ARP. Once this command is configured, it overrides any dynamic ARP.
ieee-mac-addr — Specifies the 48-bit MAC address for the static ARP in the form aa:bb:cc:dd:ee:ff
or aa-bb-cc-dd-ee-ff, where aa, bb, cc, dd, ee and ff are hexadecimal numbers. Allowed values
are any non-broadcast, non-multicast MAC and non-IEEE reserved MAC addresses.
[no] strip-label
config>router>interface
This command forces packets to be stripped of all (max 5) MPLS labels before the packets are
handed over for possible filter (PBR) processing.
If the packets do not have an IP header immediately following the MPLS label stack after the strip,
they are discarded. Only MPLS encapsulated IP, IGP shortcuts and VPRN over MPLS packets will
be processed.
This command is only supported on:
• Optical ports
• IOM3-XP cards
• Null/Dot1q encaps
• Network ports
• IPv4
The no form of the command removes the strip-label command.
In order to associate an interface that is configured with the strip-label parameter with a port, the port
must be configured as single-fiber for the command to be valid.
no strip-label
tos-marking-state {trusted | untrusted}
no tos-marking-state
config>router>interface
This command is used on a network IP interface to alter the default trusted state to a non-trusted state.
When unset or reverted to the trusted default, the ToS field will not be remarked by egress network IP
interfaces unless the egress network IP interface has the remark-trusted state set, in which case the
egress network interface treats all IES and network IP interface as untrusted.
7710 SR OS Router Configuration Guide