Alcatel-Lucent 7710 SR OS Configuration Manual page 451

If the packet being logged does not have a source or destination MAC address (i.e., POS) then the
MAC information output line is omitted from the log entry.
In case log summary is active, the filter log mini-tables contain the following information..
7710 SR OS Router Configuration Guide
Label
Protocol
Flags
(TCP flags)
HEX
Total Log
Instances
(Allowed)
Total Log
Instances (In Use)
Total Log Bindings
Type
Filter ID
Entry ID
Log
Instantiated
Label
Summary Log LogID
Crit1
TotCnt
ArpCnt
Description (Continued)
The IP protocol of the logged packet (TCP, UDP, ICMP or a protocol
number in hex).
Urgent bit set.
URG —
Acknowledgement bit set.
ACK —
Reset bit set.
RST —
Synchronize bit set.
SYN —
Finish bit set.
FIN —
If an IP protocol does not have a supported decode, the first 32 bytes
following the IP header are printed in a hex dump.
Log entries for non-IP packets include the Ethernet frame information
and a hex dump of the first 40 bytes of the frame after the Ethernet
header.
Specifies the maximum allowed instances of filter logs allowed on the
system.
Specifies the instances of filter logs presently existing on the system.
Specifies the count of the filter log bindings presently existing on the
system.
The type of service of the service ID.
Uniquely identifies an IP filter as configured on the system.
The identifier which uniquely identifies an entry in a filter table.
Specifies an entry in the filter log table.
Specifies if the filter log for this filter entry has or has not been instan-
tiated.
Displays the log ID.
Summary criterion that is used as index into the mini-tables of the log.
The total count of logs.
Displays the total number of ARP messages logged for this log ID.
Filter Policies
Description
Page 451