Piper Arrow IV Turbo Maintenance Manual page 426

ANTI-COLLISION LIGHT. (Strobe)
DESCRIPTION.
The lights are located on each wing tip in the same assembly with the navigation lights. They are rated to
flash at approximately 50 times a minute.
REMOVAL OF WING TIP STROBE LIGHT.
1. Remove the screw securing the navigation light cover and remove cover.
2. Remove the three screws securing navigation light bracket assembly and pull out.
3. Remove the strobe lamp by cutting the wires on the lamp beneath the mounting bracket.
4. Remove the defective lamp.
5. Remove and discard the plug with the cut wires from its electrical socket.
INSTALLATION OF WING TIP STROBE LIGHT.
1. Route the wires from the new lamp down through the hole in the navigation light bracket.
2. Insert the wire terminals in the plastic plug supplied with the new lamp. Wire according to the
schematic diagram located in the back of this section. Connect the plug to the receptacle.
3. Position strobe lamp on navigation light bracket.
4. Secure navigation light assembly and bracket with appropriate screws.
5. Install navigation light cover and secure with appropriate screw.
PIPER AIRCRAFT
PA-28RT-201 / 201T
MAINTENANCE MANUAL
2G3
33-40-06
Page 33-07
December 1, 1978