Concluding Steps - Fujitsu PRIMERGY RX1330 M3 Upgrade And Maintenance Manual

System board and components

14.7.1.4 Concluding steps

"Installing the iRMC microSD card" on page 298
Ê
"Installing the SATA DOM" on page 294
Ê
"Installing the TPM" on page 285
Ê
"Installing the UFM" on page 276
Ê
Ê Install the memory modules, see section
page 226.
I
Make sure that you reinstall each memory module in the slot it was
located before the replacement.
Ê Install the heat sink, see section
Ê Install all expansion cards, see section
page 197.
I
Make sure that you reinstall each card in the slots it was located
before the replacement.
"Reassembling" on page 60
Ê
"Connecting the power cord" on page 64
Ê
Ê Connect all external cables.
"Switching on the server" on page 66
Ê
I
If the Global Error LED is flashing with the error message "CPU has
been changed" on the display after the system is powered on, please
follow the steps below.
Ê Restart the system and wait until the screen output appears.
Ê Press [F2].
Ê If a password is assigned, enter this password and confirm with
[Enter].
The BIOS setup main menu will be displayed on the screen.
Ê Select "Save Changes and Exit" or "Save Changes and Reset" on
the Save & Exit menu.
Ê Confirm that the Global Error LED is off.
This is only information regarding to the change of the CPU
configuration. There is no technical problem.
308
(if applicable)
(if applicable)
"Installing the heat sink" on page
Upgrade and Maintenance Manual
(if applicable)
(if applicable)
"Installing a memory module" on
"Expansion cards and riser cards" on
240.
RX1330 M3