Preliminary Steps; Replacing The Defective Cmos Battery - Fujitsu PRIMERGY RX1330 M3 Upgrade And Maintenance Manual

14.2.1.1 Preliminary steps

"Locating the defective server" on page 50
Ê
"Shutting down the server" on page 53
Ê
"Disconnecting the power cord" on page 54
Ê
"Getting access to the component" on page 55
Ê
Ê If there is an expansion card attached to slot 3, remove the riser module 3
as described in section

14.2.1.2 Replacing the defective CMOS battery

1
Figure 188: Replacing the CMOS battery
Ê Press the locking spring into direction of the arrow (1), so that the CMOS
battery jumps out of its socket.
Ê Remove the CMOS battery (2).
V
CAUTION!
Sharp tools such as screw drivers might damage system board
components in case of slipping.
If the CMOS battery cannot be ejected without the help of a tool, it is
recommended to use a tooth pick.
Ê Insert a new CMOS battery of the same type into the socket (3) and (4).
RX1330 M3
"Removing the riser card" on page
2
Upgrade and Maintenance Manual
System board and components
4
3
204.
275