Preliminary Steps - Fujitsu PRIMERGY RX1330 M3 Upgrade And Maintenance Manual

System board and components

14.7.1.1 Preliminary steps

"Locating the defective server" on page 50
Ê
"Note on network settings recovery" on page 303
Ê
"Suspending BitLocker functionality" on page 71
Ê
"Shutting down the server" on page 53
Ê
"Disconnecting the power cord" on page 54
Ê
Ê Disconnect all external cables.
"Getting access to the component" on page 55
Ê
Ê Remove all memory modules, see section
page 228.
I
Before removing the memory modules, take a note on the installation
slot number for each memory module. Make sure that you reinstall
the memory modules in the slot they were located before the
replacement.
Ê Remove the heat sink, see section
I
Leave the CPU on the defective board for now.
Ê Remove all expansion cards, see section
on page 197.
I
Before removing the expansion cards, take a note on the installation
slot number for each card. Make sure that you reinstall the card in the
slot it was located before the replacement.
Ê Remove the UFM (if applicable), see section
on page 282.
I
Remove the UFM spacer from the defective system board and fasten
it with the UFM screw to the UFM board.
Ê Remove the SATA DOM (if applicable), see section
DOM" on page
Ê Remove the iRMC microSD card (if applicable), see section
iRMC microSD card" on page
304
296.
300.
Upgrade and Maintenance Manual
"Removing a memory module" on
"Removing the heat sink" on page
"Expansion cards and riser cards"
"Removing the defective UFM"
"Removing the SATA
233.
"Removing the
RX1330 M3