Power supply unit (PSU)
Installing hot-plug PSU and dummy cover
Ê Install the PSU as described in section
page
110.
I
The PSU must be installed in the first bay (left bay seen from rear
side). The dummy cover must be installed in the second bay.
Ê Install the dummy cover as described in section
on page
115.
Installing the additional fan module
Figure 49: Removing the sponge
Ê Remove the sponge.
Figure 50: Routing fan cable
Ê Thread the fan cable through the opening of the fan cage and insert the fan
module. Notice the direction of the fan label (see circle).
130
Upgrade and Maintenance Manual
"Installing a hot-plug PSU" on
"Installing the dummy cover"
RX1330 M3