Table of Contents
Advertisement
13
Front panel
Safety notes
V
CAUTION!
When inserting the front panel into the server, ensure not to pinch or
●
strain any connected cables.
Circuit boards and soldered parts of internal options are exposed and
●
can be damaged by static electricity. Always discharge static build-up
(e.g. by touching a grounded object) before handling electrostatic-
sensitive devices (ESDs).
Do not touch the circuitry on boards or soldered parts. Hold circuit
●
boards by their metallic areas or edges.
For further information, please refer to chapter
●
information" on page
13.1
Basic information
In case of a defective ambient temperature sensor, please replace the front
panel.
Front panel module
The front panel module consists of a holder and a front panel board. These
components are already pre-assembled. The USB connector of the front USB
cable must be installed in the dependant recesses of the holder. As an option
the holder can be equipped with a front VGA connector.
Front panel on QRL (10 x 2.5-inch HDD configuration)
The front panel on QRL (Quick Release Lever) is only available for the servers
with a 10 x 2.5-inch HDD configuration. The front panel is mounted on the right
QRL. A flat cable is used for connection to the system board.
RX1330 M3
35.
Upgrade and Maintenance Manual
"Important
257
Advertisement
Table of Contents
