VERITAS NetBackup 5230 Hardware Installation Manual page 45

Accessing and using the Veritas Remote Management interface
Note: Alert configuration is not supported using the Veritas Remote Management
interface. Alert configuration is supported from either the Settings > Notification
> Alert Configuration menu in the NetBackup Appliance Web Console or the
Settings > Alerts command view in the NetBackup Appliance Shell Menu. For
details, see the Settings > Notifications > Alert Configuration section in the
NetBackup Appliance Administrator's Guide or the Main > Settings > Alerts view
commands section in the NetBackup Appliance Commands Reference Guide.
Before you use the Remote Management interface, the following prerequisites must
be met:
The Remote Management interface must first be configured using the NetBackup
■
Appliance Shell Menu.
At least one power cable must be connected to a functioning power source.
■
At least one user must be enabled to use the LAN channel(s).
■
To access and use the IPMI web interface from a remote computer
1
Log on to a remote computer in the network and open a supported Windows
browser.
2
Enter the remote management port IP address that is assigned to the remote
management port. The following page appears:
3
Enter your login information. The default user name is sysadmin. The default
password is P@ssw0rd, where 0 is the number zero.
Click Login.
Verifying hardware operation and configuring IPMI 45