Connecting The Power Cables - VERITAS NetBackup 5230 Hardware Installation Manual

Connecting the power cables

3
Remove an optical fiber from its packaging.
4
Remove the caps of the optical connectors.
5
Plug an optical connector into the interface of the card.
6
Ensure that the optical connector is securely inserted into the optical transceiver.
7
Connect the other optical connector of the optical fiber to a Fibre Channel
switch.
See "About the cables"
Caution: The equipment should be completely installed and all network cables
should be connected before any devices are connected to power sources.
The rear panel of the appliance has two power modules. Each module requires a
separate AC power cable or PDU cord. Connect one end of the cable or cord to a
power module. Then, plug the other end into a 110 VAC or a 220 VAC socket.
The rear panel of the 3U16 storage shelf also has two power modules. Each module
requires a separate AC power cable or PDU cord. Connect each module to a 110
VAC or a 220 VAC socket.
on page 27.
Connecting the power cables
Cables 34