VERITAS NetBackup 5230 Hardware Installation Manual page 129

Adding 2U12 storage shelves to an operational NetBackup 5230 Appliance
8
Verify that the Power on/Standby LED is green.
If the Power LED or the other two LEDs are amber, escalate the issue.
The default Unit ID display is 88. You are not required to change this number.
The following table provides details of the control panel LEDs.
System Module fault
power (Amber)
(Green or
Amber)
On (Amber) Off
On (Green) On (Amber)
On (Green) Off
On (Green) On (Amber)
On (Green) On (Amber)
On (Green) On (Amber)
On (Green) Flashing
Turning on the hardware and verifying operation
Logical fault Associated
(Amber) LEDs and
alarms
Off None
N/A Single beep,
then double
beep
Off None
N/A Power Cooling
Module (PCM)
fault LEDs
Fan fault LEDs
N/A I/O module LED
N/A None
N/A Module fault
LED located on
an I/O module
129
Status
Standby power
present, the
overall power
failed or turned
off
Control panel
power is on, in
test state (5
seconds)
Power is on, all
functions are
good
Any PCM fault,
fan fault, or an
over or under
temperature
issue
Any I/O module
fault
Enclosure
logical fault
Unknown I/O
module type
installed
(Invalid or
mixed)