VERITAS NetBackup 5230 Hardware Installation Manual page 65

Adding 3U16 storage shelves to an operational NetBackup 5230 Appliance
This list describes the numbered components in the diagram.
1 - Location of a screw on the rear of the storage shelf handle. Insert the
■
screw here to connect the bottom of the rail to the rack. The shelf sits on
the ledge of the rail.
2 - Location of a second screw to hold the storage shelf to the rack.
■
2
Locate the left mounting rail in the box in which the 3U16 storage shelf is
shipped. The mounting plate at the front end of the rail is marked Front Left.
3
Install snap-in cage nuts in the rack as follows:
Locate the M5 snap-in cage nuts in the package in which the storage shelf
■
was sent.
Identify the bottom third of the 3U section in the front and back of the rack
■
where you want to install the storage shelf.
Note: The mounting rails are 1U high. The holes that are used to secure
the rail in the rack are in the middle of that height.
From the inside of the rack, insert snap-in cage nuts in cutouts in the front
■
and back where you want to install the mounting rail. Make sure that the
nuts are installed at the same level.
4
Orient the left mounting rail so that the lip is at the bottom and on the inside of
the rack. You can adjust the length of the rail to fit the depth of the rack.
Note: The lip on the rail that supports the 3U16 storage shelf must be on the
inside of the rack and at the bottom of the rail.
5
Align the screw holes in the rail with the snap-in cage nut that you installed in
the rack
6
Insert M5 screws and tighten. Screws are shipped with the unit.
7
Repeat these steps for the right rail. Be sure that rails are installed at the same
height.
Installing the 3U16 Storage Shelf into a rack
Caution: Due to the weight of the units, Veritas recommends that storage shelves
be installed at or near the bottom of the rack.
Installing 3U16 storage shelves into the rack
65