VERITAS NetBackup 5230 Hardware Installation Manual page 132

Adding 2U12 storage shelves to an operational NetBackup 5230 Appliance
To turn on the appliance
1
Connect both AC power connectors on the rear panel of the appliance to two
main AC power supply outlets.
2
Turn on the appliance, using the power button which is located on the right
side of the front panel.
3
Determine if the appliance is running properly.
Check the Status LED (1), and Activity (2) LED on the installed disk drives
■
on the front panel.
The Status LED (1) should not be lit. The following indications are possible:
A solid, amber, LED indicates a disk fault.
■
A blinking, amber, LED indicates that a RAID rebuild is in progress.
■
The Activity LED (2) indicates the following:
The LED is not lit when the disk has spun down, although power is on.
■
The LED is solid green when there is no disk activity, although power
■
is on.
The LED blinks green when the disk spins up.
■
The LED blinks green occasionally when commands are processed.
■
Review all LEDs on the front control panel.
■
Turning on the hardware and verifying operation
132