Installing The Additional Memory - VERITAS NetBackup 5230 Hardware Installation Manual

Installing the additional memory

Adding 3U16 storage shelves to an operational NetBackup 5230 Appliance
Put on a grounded ESD wrist strap or take other precautions against ESD
■
damage.
Remove the four screws (1) from the top of the chassis cover as shown in
■
the figure above.
Press the blue thumb grips (2) to release the locks and slide the cover back
■
0.5 inches (1.27 cm).
Lift the cover off the chassis and set it aside where it cannot be damaged.
■
Base NetBackup 5230 appliances are equipped with 64GB of memory in the form
of Dual In-line Memory Modules (DIMMs). When a base unit is upgraded to use
storage shelves, 64GB of additional memory must be installed.
To install the memory
1
Remove the air duct as follows:
Note: The air duct is the plexiglass cover behind the fan bulkhead as shown
in the following figure. The air duct has two blue latches attached.
Installing the additional memory
52