Accessing And Using The Veritas Remote Management Interface - VERITAS NetBackup 5230 Hardware Installation Manual

Accessing and using the Veritas Remote
Management interface

Accessing and using the Veritas Remote Management interface

6
Enter the following command if you want to add a new user to access the IPMI
sub-system. Note that this is an optional step.
IPMI User Add <User_Name>
At the New Password prompt, enter a password for the user.
The default user name is sysadmin. The default password is P@ssw0rd,
where 0 is the number zero.
At any point in time, you can run the following command to view the users who
can access the IPMI:
IPMI User List
7
Type Return to return to the Main_Menu prompt.
8
Use a Cat5 or a Cat6 cable to connect the remote management port to the
network.
9
Make sure you can reach the Veritas Remote Management Console over the
network by using the new address in a web browser.
10
The appliance is ready for initial configuration. See the NetBackup Appliance
Initial Configuration Guide for the appropriate platform for information about
initial configuration requirements and procedures.
Note: Once the initial configuration has been completed, you can connect NIC1
(eth0) to an administrative network that does not provide any backup data
transfer.
The IPMI web interface is known as Veritas Remote Management interface. You
can use Veritas Remote Management interface to log on to the NetBackup Appliance
Shell Menu.
Verifying hardware operation and configuring IPMI 44