VERITAS NetBackup 5230 Hardware Installation Manual page 43

Configuring the IPMI from the NetBackup Appliance Shell Menu
The defaults for the remote management port are:
IP Address: 192.168.0.10
■
Subnet Mask: 255.255.255.0
■
Also review the following section on the IPMI prerequisites.
See "Prerequisites for IPMI configuration"
To configure the IPMI port by using a keyboard and monitor
1
Connect the following components to the appropriate ports on the rear panel
of the appliance:
A standard video cable between the VGA (Video Graphics Array) port and
■
a computer monitor.
A USB keyboard to a USB port on the appliance.
■
2
Verify that the appliance is turned on.
Once the startup process is complete, a login prompt appears.
3
Enter the username and password for the appliance. By default, the user name
is and the password is
admin
4
At the Main_Menu prompt, type Support to navigate to the Support menu.
5
From the Main_Menu > Support view, enter the following command to
configure the remote management port:
IPMI Network Configure <IPAddress> <Netmask> <GatewayIPAddress>
where IP address is the new IP address of the remote management port. The
Subnet mask and Gateway enable connectivity between your network computer
and the remote management port.
The remote management port must be configured as a DHCP or static address.
At any point in time, you can run the following command to see the IPMI network
details:
IPMI Network Show
Verifying hardware operation and configuring IPMI
on page 19.
where 0 is the number zero.
P@ssw0rd
43