Veichi Electric AC60 series Manual page 132

0：Frequency pulse output
1：0～20mA
2：4～20mA
3：0～10V
Tips: after the software select the output mode, user need to select the short
connect mode of the terminal pin J1,J2,J3. The concreter selection ways
as follows:
When select frequency pulse output mode, pls short connect the
J1,disconnect the J2、J3.
When select 0～20mA or 4～20mA output mode, pls short connect the J2,
disconnect the J1、J3.
When select 0～10V output mode, pls short connect the J3,disconnect the
J1、J2.
When frequency inverter leaving factory, both software and hardware are
defaulted as frequency pulse output mode. If user needs to change, please
change both software and hardware at the same time according to the
actually output.
F-63 （AO1）output signal
gain
F-64 （AO2）output signal
gain
Used to adjust the analog quantity of （AO1）terminal and numerical value of
（AO2）output signal.
F-65 （ AO1 ） output signal zero
adjust
Factory settings is 0.2KHz～10.0KHz；
Range ：25%～200%
Range ：25%～200%
Range ：-10%～10%
128
Factory
setting ：100%
Factory
setting：100%
Factory
setting：0%