Veichi Electric AC60 series Manual page 122

If the output current continues to be over the setting level of the parameter
［F-36］ ，after the delay time［F-37］ ，the output terminal outputs valid signal.
In the same way，when the output current is lower than the setting level of
［F-36］ ，after the delay time［F-37］ ，the output terminal outputs invalid
signal.
F-38 Timer setting value
This parameter is used to time for the frequency inverter. The timer
start-up is accomplished by the exterior trigger terminal of the timer（trigger
terminal is selected by［F-01～F06］ ）. Timing from receiving the exterior
trigger signal, while reaching the timed time, it outputs width is 500ms pulse
signal by the corresponding output terminal.
F-39 Counter maximum
value
F-40 Counter setting
value
Range:0.1～65000 second
Range ：1～65000
Range ：1～counter maximum
value
118
Factory setting:
1 second
Factory
setting：1000
Factory
setting ：100