Veichi Electric AC60 series Manual page 129

Terminal input upper
F-57 limit
frequency
These two parameters stipulate the corresponding relation between the exterior
input analog quantity, upper/lower limit of the pulse signal and the frequency.
F-58 Input signal
characteristic
selection
LED 0 digit：VS1 input characteristic selection
0：Positive characteristic 1： Negative characteristic
LED 10 digit：AS input characteristic selection
0：Positive characteristic 1： Negative characteristic
LED 100 digit： VS2 input characteristic selection
0：Positive characteristic 1： Negative characteristic
Tips: when（VS2）opens bipolar function([F-48]is set as "1" or "2"), this
parameter is invalid.
LED kilo digit： Impulse input characteristic selection
0：Positive characteristic 1： Negative characteristic
When in positive characteristic stage, lower limit of exterior analog
input quantity and the pulse signal corresponds to [ F-56 ], upper limit of
exterior analog input quantity and the pulse signal corresponds to [ F-57 ].
When in negative characteristic stage, lower limit of exterior analog
input quantity and the pulse signal corresponds to [ F-57 ], upper limit of
exterior analog input quantity and the pulse signal corresponds to[ F-56 ].
As shown in the chart [F-56] (fmin), the biggest analog input and the
pulse signal corresponding frequency setting means their upper limit value
corresponding frequency setting, As shown in the chart [ F-57 ] (fmax).
Range ： ［F-56］～maximum
setting
frequency
Range ：0000～1111
125
Factory
setting：50.00
Hz
Factory setting：
0000