Veichi Electric AC60 series Manual page 120

Counter
14
setting values
PID feedback
15 quantitative
limit alarm
PID feedback
16 quantitative
limit alarm
17 Sensor disconnect
Program running
18
cycle completed
Program running
19
step completed
Tips: relay output terminal TA-TC connect、TB-TC disconnect is valid signal.
Low level Y1、Y2 output terminal, conbinated with （+24V）terminal, output
24V voltage which is valid signal.
counter clear to "0".
When the counter reach the setting values,
output terminal output valid signal. When
reach
counter further counts to surpass the maximum
values and the counter clear to zero, this
output signal abolishes.
When the PID feedback quantity reaching
upper the alarming upper limit［H-26］ is detected，
it outputs signal.
When the PID feedback quantity reaching
lower the alarming lower limit［H-27］ ，it outputs
signal.
While the frequency inverter detects the
feedback signal in PID control mode, if the
feedback signal is smaller than［H-28］,what
means the sensor
signal.
When program finishes the periodic running, it
output 500ms low level signal.
When program finishes the step running, it
outputs 500ms low level signal.
116
disconnects,it outputs