Terminal Operation Control Mode - Veichi Electric AC60 series Manual

frequency inverter, frequency inverter will be in the stop and locking
state. At this moment, if you want to use the terminal or RS485 operation
order channel to restart the frequency again, you must send the stop order
by the selected channe. The frequency inverter can rerun after unlock.
LED 1000 digit：After fault reset, terminal operation mode selection
0：Terminal control to power on directly
1：Terminal control to power off firstly,then start
Attention: when the frequency inverter fault alarms, three running order given
channels can send valid reset signal to the frequency inverter. If the
frequency inverter adopts the terminal control mode, after frequency
inverter reset by receiving the other two channels' reset signal, this
parameter can be used to select whether to carry on the terminal operation
order.
F-0 Terminal operation
8 control mode
0：Standard rotational control
2：Three linear rotational controls
Range ：0 ～ 2
1：Double linear rotational control
109
Factory
setting ：0