Installation: First the tail-hood upwardly inclines around 15 degrees and
inserts the top fixed flat into the fixed hole in the front cover. Then slightly
press the tail-hood downward. While your hear "Ka",it means that the tail-hood
is into the place.
Dismantlement: At the tail of the frequency inverter, there is a special
dismantlement hole design. Put your fingers into the hole, upwardly pull the
cover with a little force until the buckle between the tail-hood and the crust
tear off, and then removed tail-hood down.
3.5 Dismantle and install keyboard
Installation : Put down the keyboard aimed at keyboard installation groove,
maintain the keyboard and cover parallel, press the keyboard down with uniform
strength until you hear "Ka" which means the installation of the keyboard in
place. Please do not tilt the installation of the keyboard.
16