Veichi Electric AC60 series Manual page 138

0：Keyboard potentiometer
signal.
1：PID keyboard number given
［H-16］.
2：Exterior exterminal VS1
10V）analog signal.
3：Exterior exterminal AS
20mA）analog signal.
4：Exterior exterminal VS2
signal.（[F-48] can not be "1"or "2"）.
5：Exterior pulse signal
frequency signal.
6：RS485 interface
interface.
H-13 PID controller feedback
signal sources
0. Exterior exterminal（VS1）
10V）analog signal.
1. Exterior exterminal（AS）
20mA）analog signal.
2. Exterior exterminal（VS2）
signal.（[F-48] can not be "1"or "2"）.
3. Exterior pulse signal
frequency signal.
Attention: PID controller given signal source and PID controller feedback
signal source can not be set as the same channel; otherwise PID can not work
normally.
Given by the keyboard potentiometer analog
When applied to normal PID，setting by the
Given by the exterior exterminal（VS1） （0V～
Given by the exterior exterminal（AS） （4～
Given by the exterior exterminal（VS2）analog
Given by the exterior exterminal（PUL）pulse
Given by the signal received by RS485 communication
Range ：0 ～ 3
feedback by exterior exterminal（VS1） （0V～
feedback by exterior exterminal（AS） （4～
feedback by exterior exterminal（VS2）analog
feedback by exterior exterminal（PUL）pulse
134
Leave factory
value ：1