Basic Parameters Detailed Specification; Chapter Seven Function Detailed Specification - Veichi Electric AC60 series Manual

Chapter seven Function Detailed Specification

7.1 Basic parameters detailed specification

Execute commands
E-01
channel selection
Select channels which are used to accept operation and stop orders and the
running direction. When restore factory setting，the setting values can
not be changed.
0：Keyboard control
inverter is control by the rotating run keys FWD , reverse operation or
jog keys REV / JOG and parking key STOP / RESET above the Keyboard. REV
/ JOG key parameters is defined as reversion when the [E-08] set to "0",
is defined as jog when the parameters [E-08] set to "1", see [E-08].
1：Terminal control
inverter is control by whether connect the control terminal: Forward
Rotating （FWD）or reverse(REV) to （COM）or not.
2：RS485 Communication
inverter is control by the signal which receive by the RS485
communication port.
Attention: When the fault reset, the STOP / RESET button above the keyboard,
control terminal reset order 、RS485 communication port are effective
reset orders.
Tips：1、When program control, (VS2) input bipolar adjustment, and direction
controlare valid([F-48] setting is 1),the operation direction of the
frequency inverter can not be control by this orders channel.
2、The STOP / RESET key above the keyboard is function selectable. Under
exterior terminal control or communication control, it can be defined
as urgent stop key, please reference the parameters [F-07]; Under
exterior terminal operation control, if use STOP / RESET to stop, the
given
Range ：0～2
The operation,stop and direction of the frequency
The operation, stop and direction of the frequency
The operation,stop and direction of the frequency
64
Factory
setting：0