Configuring Router - Ruijie RSR10 Series Hardware Installation Manual

Installation Manual
Copyright (c) 1998-2009 by Ruijie Networks.
All Rights Reserved.
Decompiling or Reverse Engineering is Not Allowed.
00:00:00:00: %MTD_DRIVER-5-MTD_NAND_FOUND: 1 NAND chips(chip size : 33554432) detected
00:00:00:00: %MTD_DRIVER-5-MTD_NAND_FOUND: 1 nand chip(s) found on the target.
00:00:00:17: %LINK-5-CHANGED: Interface FastEthernet 0/1, changed state to up
00:00:00:17: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet 0/1, changed
state to up
00:00:00:17: %LINK-5-CHANGED: Interface FastEthernet 0/0, changed state to up
00:00:00:17: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet 0/0, changed
state to up
00:00:00:31: %SYS-5-COLDSTART: System coldstart.
Ruijie>
Ruijie>
Ruijie>
Ruijie>
Ruijie>
（Such information may vary with hardware configuration or software version.）
Suggestion
4.2

Configuring Router

Before using the router, you will have to configure it as needed. For more information on
router configuration, see the related Configuration Guide and Command Reference.
When using the router for the first time, it is recommended setting basic
parameters using the configuration function.
Chapter 4 Starting and Configuring Router
4-3