Table of Contents
Advertisement
Servo speed
The Servo speed setting is used to set the servo
delay for each channel, from channel l to channel
16. The system uses the programmed speed (delay)
to slow down servo position changes. The Servo
Tap the [Servo speed] button in the Linkage
menu to call the setup screen shown below.
Return to Linkage menu
Servo speed setting
1. Tap the speed button of the channel you
want to set.
2.
se the value input buttons to adjust the
servo speed.
Initial value: 0
Adjustment range: 0~27 (steps)
Sub-trim
The Sub-Trim function is used to set the servo
neutral position, and may be used to make fine
adjustments to the control surface after linkages
Tap the [Sub-trim] button in the Linkage menu to
call the setup screen shown below.
Return to Linkage menu
Sub-trim adjustment
1. Tap the trim display part of the channel you
want to adjust.
Value input buttons appears on the Sub-trim
menu screen.
Sets the speed of each servo.
speed setting can be varied from 0 to 27 in each
channel.
（First） 0 ∼ 27 （Slowly）
3. Repeat this procedure for each channel.
To close this screen, tap the [Servo speed]
button.
Setting of neutral position of each servo.
and pushrods are hooked up. When you begin to set
up a model, be sure that the digital trims are set to
their center position.
2. se the value input buttons to adjust the sub
trim.
Initial value: 0
Adjustment range: -240~+240 (steps)
*See above
3. Repeat this step for each channel.
＜ Linkage menu ＞
73
Advertisement
Table of Contents
